2013 Jeep Wrangler,Manual Trans, EVO-One-942 kit, THAR-CHR5, will not remote start after ready mode entered

Question

2013 Jeep Wrangler, Standard key (no OEM remote),Manual Trans, EVO-One-942 kit, THAR-CHR5, will not remote start after ready mode entered.  I have followed install guide #63811.  

After successfully entering ready mode and trying to remote start it will power the jeep up like itis trying to start it but nothing happens.  After reading a few of the other question/answers it seems that a clutch bypass relay may need to be installed?    I have found some information on wirecolor.com for the wiring of this.  Does this relay connect back to the EVO-One somewhere?  Installing a clutch bypass relay is not mentioned anywhere in the #63811 install guide.  Perhaps you guys should include that in the guide.

Answer 1

Hello,

Guide 63811 is for for automatic tranmission.

Yes a clutch bypass will need to be wired in, you can use the drk blue ground out wire on the 20 pin of the evo-one to trigger the realy you will need to add for the clutch bypass.

Best regards

Comments

Can you give me a link to the install guide for a manual transmission because I looked all over Fortin's website and could not find one mentioned anywhere.

---

Fortin does not make manual transmission installation guides for the most part, normally you would follow the automatic guide and then it is the installers responsibility to add/wire in the additional connections required for manual transmission vehicles.

---

Got it all wired up and it works.  For anyone looking to do this its a lot easier to access the wires for the clutch switch if you remove the horn, and relays above it.  Then to unplug the connector from the clutch master find a small flat blade screwdriver and push it in between the side of the jeep and connectorand turn a little to press the release.  You will see what I mean when you get in there.

Here is the wirind diagram for the relay:

https://image-1.wirecolor.com/vehiclegroupimage/69231.jpg