Subaru Impreza, computar and Evo all

Question

Hello, I have a 2016 Subaru Impreza with a Compustar alarm and an Evo-All module. Everything works fine while the vehicle is off. lock, unlock, trunk, etc. But when I use the remote start, the vehicle unlocks the doors to disarm the alarm and starts normally, then the lights flash as if it's locking again, but it doesn't. If I press the lock button on the Compustar remote, the vehicle's lights flash as if it's locking, but nothing happens. However, if I use the original remote, it locks properly. It seems that the Evo-All module isn't responding when the car is running. I've been having this problem lately with Subarus when using a Compustar remote start and an Evo-All module. What can I do? Thanks.

Evo all   Sn: 001A07732407     05/2025

Answer 1

Hello,

I would take a look at the door lock data wire, this is were the door locks are done when the vehicle is remote started.

Otherwise you could always just connect the lock and unlock wires from the compu to the vehicle.

Best regards