2013 Ford Fusion 1.6 Manual - Clutch bypass pinout

Question

Hi,

Does the evo one support manual mode for the a  2013 fusion manual? Need the pinout from the bcm to bypass the clutch switch for remote start. Does it need to be driven by a relay? Also will the evo one detect the electronic handbrake via CAN? Can I use the t harness and then wire in the bypass separately?

Answer 1

Hello,

Yes the evo-one can work in a 2013 Ford Fusion standard key with manual tranmission.

Doors, Tach, footbrake & handbrake would all be detected through Can-Bus.

Evo-One does support the thar-for2 harness for this vehicle, please note 2 oem keys are required for programming.

For the clutch bypass it is the installers responsibility to test and determine the clutch type and polarity. Relays can be required depending on vehicle configuration.

Please note Fortin tests its solutions on vehicles based in the North American market, if the vehicle is outside of that market range compatibility cannot be guraranteed. Fortin does not assist end consumers who attempt to work on manual transmission vehicles, installation by a qualified professional is strongly recommended.

Best regards