Question

Programming procedure step number 5, start engine, solid red and blue.

I held the button down, then plugged the evo one in. Made sure it had red and blue solid. Then pressed it 6 times so the leds blink 5 times. Then i insert the key into the ignition and start the car. The led lights stay on blue and red, when it's suppose to alternate red and yellow.

Subaru crosstrek 2018

Answer 1

Hello,

 

What is the S/N number to the module?

A few things you can check:

- if using the sub3 harness ensure you have connector A plugged in

- if the red led does not flash rapidly when starting the vehicle, verify IMO connections

 

Best regards

Comments

Hello,

Thank you for the response. It turns out I did not connect the A10 (lt. blue/black) with D1 (yellow/green).

In addition, I also did not connect T-Harness Sub3 A plug and B plug to the appropriate connection. A male goes to A female, and B male goes to Jumper B female. I noticed the issue was during dcryptor programming procedure step 5, the blue led will not flash rapidly.

Thank you to the support team who picked up my call when I called and for responding to my question.

Other notes:

-Guide # 99371

-THARNESS THAR-ONE-SUB3 page 6

-Video I used as a reference https://www.youtube.com/watch?v=FYkYdKyye3c