Hello,
My 2009 Honda Civic Manual Transmission is not entering Ready mode. I have an Evo One with T-harness thar1 installed. I had this installed previously in my last Civic of same model and year. I did reset the module and update the firmware since I hadn't programmed it in a few years. With the car running, I apply and hold the foot brake, apply the hand brake, then release the foot brake. It should flash the cars lights and enter Ready Mode at this point, but does not. I am wondering if it is the firmware update or an option I changed by mistake causing the issue.
Bypass Options:
Firmware: 73.[41]
Hardare: 4.0
A1 Door Locks
A3 Key Bypass
A7 Foot Brake (Output Status)
A8 Hand Brake (Output Status)
A9 Door Trigger (Output Status)
A10 Trunk Trigger (Output Status)
B1 Unlock Driver Door Only
C1 OEM Remote Monitoring
D2 Unlock Before/Lock After (Disarm OEM Alarm)
D4 Hybrid Mode
D5 Lock After Start
Remote Starter:
2.1 Programmable Output (+) IGN/ACC/START
3 Tachless Sensitivity 1
4.1 Remote Car Starter Runtime 15 MIN
6.1 Door Lock Before And After Remote-Start NO
7.1 Ignition Door Lock NONE
8.1 Unlock Pulse Time SINGLE 0.25
9.1 Active or Passive Starter Kill ACTIVE
10.1 Starter Kill Output
11.1 Confirmation Sound and Antenna LED
12.1 Output Horn/Siren
13.2 Confirmation Pulse SHORT
14.1 Alarm On/Off Starter On/Off
15.1 Smart Door Lock
16.5 Cold Start Timer OFF
18.1 Diesel Mode DISABLE
19.1 Turbo Mode DISABLE
20.6 Engine Supervision
21.1 Start Attempts 2 Times
24.1 Special Applications DISABLE
25.1 Yellow/Black (A13):Aux1
26.1 Hybrid Mode GAS / Diesel Vehicle
29.1 Alarm Duration 30 Sec
30.1 Valet Code
31.1 Special Application Programmable Output (+) DISABLE
32.1 Ground Output
33.2 Manual Transmission Ready Mode Activation Hand & Foot Brake ON
35.1 Door Unlock Special Application DISABLE
36.2 Activation/Deactivation Remote Valet Mode
37.1 Security Remote Car Starter Special Application DISABLE
38.2 System Control by OEM Remote 3x LOCK
39.1 Temperature Option DISABLE
Thank You.
