2023 Toyota Tacoma pts stuck at last step (Dcryptor)

Question

I install Evo One, Thar-Toy6 harness, and 942 rf kit. Flash for remote start and alarm, siren (a7), shock sensor, long tone, 60 sec, and hood pin off (A11). I'm stuck at the last step Dcryptor, now saying Dcryptor limit has been reached for this car. I'm sure flash also has been reached from flashing many times along with programing step 1-5 hoping it will work lol. Please help.

module info: 11/24, Bypass sn:002B04703522 and Remote starter sn: 002B07703522 (Idk which is the sn)

Thank Al

Answer 1

Hello,

I have sent in your module for dcryptor reset, it will be ready for use wtihin 24 hours.

Please note if you are following the installation with take over you must use fw 88.xx.

If following the installation without take over (toy6) you must use fw 79.xx.

If you have any further question please feel free to contact Fortin tech support at 1-877-336-7797, mon - fri, 8am 6 pm est.

Best regards

Comments

Thank You for the dcrytor reset, I'm using Toy6 and it's flash @ fw 79.78.

 Thank again,

Al

---

Hello,

I finally had the time to try to dcryptor the Evo one module, the dcryptor programming went through. I plug back the module in the truck, no light and nothing happening. I try using the 942 remotes and still no lights nor locks, do I need to reflash, reprogram, and dcryptor the module again? I don't know what's I'm missing, or doing wrong. Any help?

Thanks

---

You need to program the 942 remotes to the evo-one.

Make sure the antenna is plugged into the blue port on the side of the evo-one module, not the t-harness.

https://fortin.ca/download/69611/EVO-ONE_QG_RM942_EN_A_69611.pdf