Key Bypass Programming stuck at Step 5 on 2009 Honda Civic Evo-One w/ T-Harness

Question

Hello,

I get stuck at Step 5 when trying to program key bypass.

1) Press and hole programming button while connection 6-pin main connector.

2) Released the programming button when the led is Red

3) Inserted the remaining connectors (A-20-pin,D-Red,C-White,B-Blue)

4) Pressed and released programming button twice (x2). Red led flashes once per second.

5) Turned key to On/Run position. Leds turned off. (Should have flashed red 10 times then blue flashing.) This is where I get stuck every time. I did notice that if I remove the 20-pin at this point, then the leds flash properly (Red x10. Blue rapidly) I replace the 20-pin and try to prepare remote start but nothing happens.

Thank you.

Answer 1

Hello,

Normally this happens when the door lock wires are connected prior to programming, as noted in the installation guide only connect the door lock wires after in vehicle programming is complete.

https://fortin.ca/download/114481/EVO-ONE_IG_THR_BI_HON1_CIVIC_KEY_2006-2011_A_114481.pdf

Best regards